Cable rollers should always be used when pulling cables.Straight cable runs are pulled in using straight cable rollers suitably placed in the cable trench to prevent the cable being dragged on the trench bottom or in mud-cable roller spacing is dependent on cable type being laid and the cable pulling tension along the route. Leading cable rollers are used to support the cable over the entire drum width immediately before being pulled into the trench.
Cable laying applications with bends in the route require skid plates of a radius greater than the cables minimum dynamic bending.
Apply to cable diameter is less than 200mm,Nylon sheaves are represented by N letters.The rest are aluminum sheaves.
  	 			Item number
 			Model
 			Applicable Cabe(MM) 			Rated load (kN)
 			Carrier Structure
 			Weight (kg)
 		
 			21171 			SHL1 			≤ Φ150 			5 			 
Casting Aluminum
Carrier
 			5.4 		
 			21172 			SHL1N 			5 			3.6 		
 			21181 			SHL1B 			≤ Φ150 			5 			 
Steel Plate
Carrier
 			5.5 		
 			21182 			SHL1BN 			5 			3.7 		
 			21183 			SHL2BN 			≤ Φ160 			5 			5.5 		
 			21184 			SHL3BN 			≤ Φ200 			5 			8.0 		
 			21191 			SHL1G 			≤ Φ150 			5 			 
Steel Pipe
Carrier
 			5.1 		
 			21192 			SHL1GN 			5 			3.3 		
 			21193 			SHL2GN 			≤ Φ160 			5 			6.5 		
 			21194 			SHL3GN 			≤ Φ200 			5 			8.5 		
  
 

Electrical Ground Cable Roller Nylon Sheave Cable Pulling Pulley

Manual Hand Winch

Marine Hand Winch

Worm Gear Winch

Cable Pulley Block

Transmission Line Tool

Underground Cable Tools

Aerial Cable Tools

Anti Twist Wire Rope

Optical Fiber Cable Tools

Hydraulic Puller Tensioner

Cable Winch Puller

Tower Erection Tools

Hydraulic Crimping Tool

Personal Safety Tools

Electrical Ground Cable Roller Nylon Sheave Cable Pulling Pulley

nylon cable pulley

bundled conductor pulley

nylon rope for pulley

Item number	Model	Applicable Cabe(MM)	Rated load (kN)	Carrier Structure	Weight (kg)
21171	SHL1	≤ Φ150	5	Casting Aluminum Carrier	5.4
21172	SHL1N	≤ Φ150	5	Casting Aluminum Carrier	3.6
21181	SHL1B	≤ Φ150	5	Steel Plate Carrier	5.5
21182	SHL1BN	≤ Φ150	5		3.7
21183	SHL2BN	≤ Φ160	5		5.5
21184	SHL3BN	≤ Φ200	5		8.0
21191	SHL1G	≤ Φ150	5	Steel Pipe Carrier	5.1
21192	SHL1GN	≤ Φ150	5		3.3
21193	SHL2GN	≤ Φ160	5		6.5
21194	SHL3GN	≤ Φ200	5		8.5